Proflush TDS 3 Meter

Checking cleanliness of system water against the mains water being used

Invisible particulates of Iron, Aluminium, Copper , Chlorides and Phosphates that are invisible to the human eye, if left in the system can cause further corrosion. Readings taken with the TDS 3 meter on the system water should be within 10% of the reading obtained on the mains water entering the system.

Specifications

• Range: 0 - 9990ppm (mg/L)
• Accuracy: +/- 2% ATC:
• Built-in sensor for Automatic Temperature Compensation of 1 to 50 degrees Celsius (33 to 122 degrees Fahrenheit)
• Power source: 2 x 1.5V button cell batteries (included)
• Battery life: over 1,000 hours of continuous use
• Dimensions: 15.5 x 3.1 x 2.3cm (6.1 x 1.25 x 1 inches) Weight with case: 76.5g (2.7 oz) Weight without case: 56.7g (2 oz)

NEW PRODUCT: Proflush PH200 pH Meter

FEATURES.

Measures pH and Temperature, Auto-ranging three point calibration with digital fine tuning. Includes 4 pH buffer solution in a sponge embedded in a clear cap, so you can see if it's dried up. Waterproof housing, Simultaneous temperature display. Measurement Range: 0-14 pH, Digital Calibration (push button). Auto-off function, data-hold function and low-battery indicator. Display: large and easy-to-read LCD screen includes simultaneous temperature reading. The PH-200 meter is three-point factory calibrated to 4, 7, and 10 pH. The meter can be recalibrated with digital calibration using the push buttons, rather than a screwdriver. Includes a cap, batteries, and lanyard.

NEW PRODUCT: Proflush TN2 Infrared Thermometer

Will enable quick checking of radiator temperatures before and during the Powerflush to establish cold spots and the completion of cleaning.

The TN2 is a non-contact infrared thermometer, possibly the smallest infrared thermometer with laser alignment on the market today, measuring only 18 x 50 x 100mm and weighing just 62 grams. Simply aim the thermometer at the target and press the read button to display the surface temperature. The TN2 indicates temperature over the range of -33°C to +220°C with a resolution of 0.1°C.
The TN2 thermometer incorporates an optical lens that measures temperature by sensing the amount of radiated energy at infrared frequencies. Using this data and the actual temperature of the infrared sensor (thermopile), the TN2 can calculate the temperature of the surface that emitted the energy.
The distance to target ratio is 3:1 therefore the thermometer should be positioned as close to the target as practical. The TN2 infrared thermometer incorporates maximum, minimum and lock (continuous) functions and is switchable between °C and °F. The unit is supplied with a default emissivity of 0.95, however, the emissivity can be changed from 0.01 to 1.

WHY NOT COMBINE THE TDS 3 AND THE TN2 THERMOMETER IN A HANDY CARRY CASE! Testing for uniform temperature on the radiators during cleaning and testing the system water for cleanliness at the end of the flush all in one box!